80
CC022D
C. Cylinder
D. Piston
NOTE: Steps 1-12 in the preceding sub-section
must precede this procedure.
13. Loosen the clamp securing the coolant hose to the union;
then detach the hose.
14. Remov e the two nuts securing the cylinder to the crank-
case.
CC023D
15. Lift the cylinder off the crankcase taking care not to
allo w the piston to drop against the crankcase. Account
for the gasket and two alignment pins.
CC024D
CC025D
CC026D
16. Using an awl, remove one piston-pin circlip.
CC032D
17. Using a suitable piston pin puller, remove the piston
pin. Account for the opposite-side circlip. Remove
the piston.
NOTE: It is advisable to remove the opposite-side
circlip prior to using the puller.
AT THIS POINT
To service cylinder, see Servicing Top-Side Compo-
nents sub-section.
CAUTION
When removing the cylinder, be sure to support the pis-
ton to prevent damage to the crankcase and piston.
To Next Page
Loading...
