Programming
channels
into
the
TV's
channel
memory
~
ICHI
When you press I
CH
I
or
~
on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the
TV's
channel
memory.
Follow the steps below to program channels into the
TV's
channel memory.
Programming
channels
automatically
Your TV can automatically detect all active channels
in your area and store them
in
its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
•
You
must configure the ANT/CABLE input
source before programming channels
(1&
page
24).
•
The
automatic channel programming process
will erase channels that were previously
programmed
into the
TV's
memory.
•
To
tune the
TV
to
a channel not
programmed
in
the channel memory, you must use the
Channel Number buttons on the remote
control.
• Programming channels when the
ANT/
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This
is
normal; however, once channel programming
is finished, you should not have
to
repeat
the programming process again unless your
Cable
TV
service lineup changes significantly.
To
program channels automatically:
1 Configure the antenna input source,
if
you have
not already done so
(1& page 24).
2
MENU
Press 0 and open the
Setup
menu.
3 Highlight
Installation
and press @.
4 (A new set
of
Installation
menu icons will appear,
as shown below.) Open the
Terrestrial
menu,
highlight
Channel
Program
to bring up the
Start
Scan,
and press @ again to begin channel
programming.
The TV will automatically cycle through all the
antenna channels, and store all active channels in the
channel memory. While the TV
is
cycling through
the channels, the message "Scanning channels,
please wait" appears (as shown above).
5
.
EXIT
To cancel channel programnung, press 0 on the
remote control (or highlight
Cancel
in
the on-screen
display and press
@).
When channel programming
is
finished, press
rM
or
ICHI
. h
~
to vIew t e programmed channels.
Setting
channel
skip
To prevent certain channels from being viewed,
channel positions can be skipped.
1 From the
Setup
menu, highlight
Installation
and
press@.
2 Press ....
or
...
to select
Channel
Options
and press
@.
The
list
of
channels will appear.
Channel Options
Ch.
Type
~
..
D'gi!61
•
••
2
A.'1alog
••
3
Q'gilal
•
•
4
Analog
••
5
Ar:abg
•
•
6
Analog
•
•
7
Ana1o<>
••
8
Analog
•
.,
3 Press .... or
...
to select a channel position to be
skipped and press
@.
A tick will appear
in
the
box. To remove the tick, press @ agaip. .
d)
(continue
25
I
To Next Page
Loading...
