Toshiba 42XL700T - Using the TVs Features - System Settings; Resetting the TV; Viewing Software Licences; Confirming Software Version

28
Using the TV’s features
Notes:
• Default setting is all On.
• A warning message will appear 1 minute before
turning off.
Resetting the TV
Reset TV will reset all TV settings, including
stored channels, to their original factory values�
1 From the SETUP menu, press s or r to
select Reset TV�
Auto Tuning
Location
Quick Setup
Software Licences
Manual Tuning
System Information
Reset TV
Home
SETUP
Menu Language
English
2 Press to select�
A screen will appear warning that all settings
will be lost� Select Yes, and then press
to
continue�
When the set powers back on, the first time
screen will appear (- page 13)� Press
to continue, and proceed to the Auto Tuning
menu (- page 16)�
Viewing the Software Licences
The licences for the software used in this TV are
available for viewing on screen�
1 From the SETUP menu, press s or r to
select Software Licences�
2 Press �
A screen will appear displaying all of the
licencing information required for the TV’s
software�
Confirming software version
1 From the SETUP menu, press s or r to
select System Information�
2 Press to display the software version�
System Information
TOSHIBA
2010
16.1.x.x. Xxx xx 2010 - xx.xx.xx FW:xx
Note:
The software version displayed is just for the
illustration.
Selecting the video input source to view
1 Press on the remote control until
the video input mode list appears on the
screen, then press s, r or to select
appropriate input source (or press o on the
TV right side panel to select required input
source directly)�
TV
Inputs
1
2
3
4
HDMI 1
HDMI 2
HDMI 3
HDMI 4
PC
2 Press �
o 1 (o (1), video 1 input) or o 1S (S-video
input),
o 2 (o (2), video 2 input),
o 3 (o (3), component video input),
o 4 (o (4), component video input),
HDMI1, HDMI2, HDMI3, HDMI4 (HDMI
input),
PC (o RGB/PC, PC input)
Notes:
• When the component video input, PC input
mode or HDMI input mode is selected, the
MONITOR OUT output terminals (- page 34)
output audio signal only.
• If a REGZA-LINK device is connected to an
HDMI input, the REGZA-LINK icon will appear.
• When the TV is switched on, it will take a few
minutes for the REGZA-LINK icon to appear in
the list; when an HDMI cable is removed, it will
take a few minutes for the icon to disappear.
• If the HDMI cable from connected device is
changed or HDMI device setting are changed,
Enable REGZA-LINK in the REGZA-LINK
Setup menu may need to be reset to On.