Adjusting the Clock Phase of the picture
If the Clock Phase, which synchronize the PC
signal and LCD display, is not optimized, the
picture will blur�
This function enables you to adjust Clock Phase
and display a clear picture�
1 From the PC Settings menu, press s or r
to select Clock Phase�
2 Press v or w to obtain a clear picture�
Adjusting the Sampling Clock
If the Sampling Clock does not match with the
dot clock frequency of the PC, blurred picture
detail will occur, or screen width will change, or
drift patterns in vertical lines may be apparent�
This function enables you to adjust it and
optimize the picture�
1 From the PC Settings menu, press s or r
to select Sampling Clock�
2 Press v or w to optimize the picture�
Resetting the PC Settings
The Reset function adjusts the PC Settings to
the factory settings�
1 From the PC Settings menu, press s or r
to select Reset�
2 Press �
Note:
When a PC is connected using HDMI none of
these function will be available.
Signal names for mini D-sub 15 pin connector
Pin assignment for RGB/PC terminal
Pin No. Signal name Pin No. Signal name
1 R 9 NC
2 G 10 Ground
3 B 11 NC
4 NC (not
connected)
12 NC
5 Ground 13 H-sync
6 Ground 14 V-sync
7 Ground 15 NC
8 Ground
Using the PC setting
• Most of the picture controls and functions are
available� However, features not available will
be greyed out�
• First press until the video input mode list
appears on the screen, then press s or r and
in order to select the PC input mode
(- page 28)�
• This function may not be available for some
signal or if no signal is received�
• The optimum points of the clock phase
and sampling clock adjustments may be
incomprehensible according to the input signals�
Adjusting the Picture Position
1 From the Display Settings in the
PREFERENCES menu, press s or r to
select PC Settings menu�
Auto Format On
4:3 Stretch Off
Picture Position
PC Settings
Display Settings
2 Press to display the PC Settings menu�
0
0
0
0
PC Settings
Horizontal Position
Reset
Sampling Clock
Vertical Position
Clock Phase
3 Press s or r to select an option you want to
adjust� Press v or w to adjust the settings as
required�
To Next Page
Loading...
