Toshiba 42XL700T - Connecting Your TV - HDMI;DVI; HDMI;DVI Device Connection Details; Connecting an HDMI Audio System; Connecting an HDMI Device

36
Connecting your TV
Connecting an HDMI or a DVI device
The HDMI input on your TV receives digital audio
and uncompressed digital video from an HDMI
device and uncompressed digital video from a
DVI device�
This input is designed to accept HDCP
programme material in digital from CEA-861-D
compliant consumer electronic devices (such as
a set top box and DVD player with HDMI and DVI
output)�
The HDMI input is designed for best performance
with 1080i (50 Hz/60 Hz) and 1080p (24/50/60
Hz) high-definition video signals, but will also
accept and display 480i, 480p, 576i, 576p, and
720p (50Hz/60 Hz (60 Hz: except for E-EDID))
and VGA (VESA 640 × 480 @ 60/72/75 Hz)
signals�
• HDMI: High-Denition Multimedia Interface
• DVI: Digital Video Interface
• HDCP: High-bandwidth Digital Content
Protection
• CEA-861-D compliance covers the
transmission of uncompressed digital video
with high-bandwidth digital content protection,
which is being standardized for reception of
high-definition video signals� Because this is
an evolving technology, it is possible that some
devices may not operate properly with the TV�
• E-EDID: Enhanced-Extended Display
Identification
• Acceptable PC signal format:
S-VGA: VESA 800 5 600 @ 56/60/72/75 Hz
XGA: VESA 1024 5 768 @ 60/70/75 Hz
W-XGA: VESA 1280 5 768 @ 60/75 Hz
W-XGA: VESA 1360 5 768 @ 60 Hz
S-XGA: VESA 1280 5 1024 @ 60/75 Hz
However, these signal formats are converted to
match the number of pixels of the LCD panel�
Therefore, the TV may not display small text
properly�
If you connect this unit to your PC, the
compressed image is displayed in S-XGA mode,
therefore the picture quality may deteriorate and
characters may not be read�
• Supported Audio format:
L-PCM, Dolby Digital, sampling rate 32/44�1/48
kHz
• L-PCM: Linear-Pulse Code Modulation
Connecting an HDMI audio system
One HDMI cable (type A connector) is needed.
1
(
ARC
)
2 31
(
ARC
)
2 3
Back of TV
AV amplifier corresponding to ARC
HDMI’s ARC (Audio Return Channel) feature
This feature enables the audio signal of the TV
to be sent to the AV amplifier via the HDMI cable�
It will not be necessary to connect a cable from
the audio output of the TV to the audio input of
the AV amplifier to reproduce the audio received
from the tuner of the TV through the AV amplifier�
Connecting an HDMI device
One HDMI cable (type A connector)
1
(
ARC
)
2 31
(
ARC
)
2 3
VIDEO AUDIO
L R
IN
OUT
HDMI OUT
USB 1 HDMI4 (2)
Back of TV
Right side of TV
HDMI device
For proper operation, it is recommended that you
use a short HDMI cable�
HDMI cable transfers both video and audio�