20
Media Guide Roller and Strip Shaft
Wipe clean the Media Guide Rollers with a soft cloth
moistened with absolute ethyl alcohol while rotating
the rollers.
Wipe clean the strip shaft with a soft cloth slightly
moistened with absolute ethyl alcohol.
Clean the strip shaft of the linerless label kit in the
same way. Cleaning should be performed each time
one or two media rolls are used up
Media Sensor Window and Media Path
Remove dust or dirt from the Media Sensor Window
with a commercially available soft, dry brush.
Wipe clean the Media Path with a soft dry cloth.
When linerless labels are used, wipe off dirt of
residual glues from the Media Guides each time one
or two media rolls are used up.
Top Cover, Operation panel, and IrDA Window
Wipe clean the cover, operation panel, and IrDA
window with a soft dry cloth slightly moistened with
absolute ethyl alcohol.
Remove any dirt or residual glues from the media
outlet with a cotton swab slightly moistened with
absolute ethyl alcohol.
When linerless labels are used, wipe off dirt of
residual glues from the Top Cover or Media Outlet
each time one or two media rolls are used up.
To Next Page
Loading...
Need help?
General