32
Serial (RS-232C) (GH20 model only)
1. Connect the serial interface cable to the RS-232C
port on the printer.
2. Connect the other end of the serial interface
cable to the host.
3. Turn on the printer and the host, and send data
from the host to the printer.
NOTE:
For details of the interface cable, please consult the
nearest TOSHIBA TEC representative.
Wireless (GH30/GH32/GH40 models only)
1. In the case of Bluetooth, place the printer within 3
m from the host.
In the case of wireless LAN, place the printer
within a wireless coverage area.
2. Turn on the printer and the host, and send data
from the host to the printer.
NOTE:
•
Please be sure to read “Precautions for Handling
of Wireless Communication Devices” before
operating the printer.
•
Confirm that there is no obstacles between the
printer and the host. Obstacles may cause a
communication failure.
The radio connectivity is affected by the operating
environment. Especially, metal obstacles, metal
powder, or locations enclosed by metal walls may
prevent proper communication.
For the installation location of access points, please
consult the nearest TOSHIBA TEC representative.
To Next Page
Loading...
Need help?
General