Toshiba B-EX6T1 - Installation for Windows XP;Server2003 (Parallel Plug & Play)

- 42 -
2.8 Installation under Windows XP/Server2003 (Parallel
interface with Plug & Play Enabled)
1. Connect the printer to the PC with a parallel interface cable.
2. Turn on the printer.
3. Set the printer parameters in the system mode.
B-SX4 Series and B-SX5 Series
CENTRO. MODE → ECP
PLUG & PLAY→ ON
B-SA4 Series, B-852-R, B-452-R, B-SX6T (305 dpi), B-SX8T (305 dpi), B-EX4 Series, B-EX6 Series
and B-462-R
PLUG & PLAY → ON
Note: For the parameter setting procedure, refer to Section 6.2 Parameter Setting on the Printer.
4. Turn on the PC
Note: Log on as the user with administrative privilege.
5. After the system is started, new hardware is
detected. When the “Found New Hardware
Wizard” is displayed, select the “Install from a list
or specific location (Advanced)”, then click the
[Next] button.
6. Select the “Search for the best driver in these
locations”, check the “Include this location in the
search” checkbox, then click the [Browse] button.
Specify the folder (C:\TEC_DRV) created in
Section 2.1, and click the [Next] button.