Toshiba B-EX6T1 - Page 52

- 50 -
Function
Description
Support
Driver Options tab
<Device Line Substitution>
When enabled, the driver will try to use the printer's
Line Commands to draw lines.
When disabled, lines are drawn by using the
Graphic Command.

<Default Copies>
Allows setting the number of copies to be printed as
default. If the number of copies is not changed
in the application, this value will be effective.

<Disable Copies Limit>
When enabled, a value exceeding “9999” can be
set for the “Default Copies”.
X
<Disable User-Defined Paper Size>
When this checkbox is checked, the user-defined
paper size “USER” cannot be used.
X
<Disable Page Size Sharing>
X
Graphics tab
Resolution
Shows the printer’s available resolution.

Dithering
Allows creating the illusion of different shades of
gray by varying the pattern of dots.

<Color Adjustment>
Allows the flip horizontal, flip vertical, rotation, color
balance adjustment, etc.

<Dithering Setup>
Allows detailed setting for the selected dithering
method.

Color
<Color Control>
Allows setting the color processing.

Stock
Media settings
<Print Method>
Allows selecting whether the ribbon is used (thermal
transfer) or not (Direct thermal).

<Sensor>
Allows selecting a sensor type used to detect a print
start position.

<Label Gap>
Allows setting the length of the gap between labels.

Issue Settings
<Issue Mode>
Allows selecting whether the labels are issued in the
strip mode.

<Post-Print>
Allows selecting whether the labels are issued in the
cut mode. Note that the Pause is not supported.

<Occurrence>
Allows selecting the cutter operation and specifying
how often labels should be cut.

<Interval>
Specifies the number of labels to be printed before a
cut operation. The cutter will cut labels after the
specified number of labels is printed.

<Print Speed>
Allows setting the print speed.

Fine Adjustment
<Feed>
Specifies the length of label that will feed after
printing.

