INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO15-33001A
(Revision Date: Jan. 19, 2006)
6. Real Time Clock: B-SA704-RTC-QM-R
6- 5
• System Setting (Date and Time Setting)
Set the date and time using the following procedure.
NOTE: Make sure that the printer version is V1.2 or greater. The real time clock is not supported by V1.1
or older.
1. Turn on the printer. “ONLINE” will be
displayed on the LCD.
2. Press the [PAUSE] key to turn the printer to
pause state.
3. Hold down the [RESTART] key until the
printer enters the system mode.
NOTE: For details of the system mode, refer to the
B-SA4T Series Owner’s Manual stored in
the CD-ROM supplied with the printer.
4. When “<1>RESET” is displayed on the LCD,
press the [RESTART] key until “<8>RTC SET”
appears.
5. Press the [PAUSE] key. The date currently
stored in the real time clock is displayed.
6. Pressing the [PAUSE] key enables changing
the Year.
7. Set the Year with the [FEED] or [RESTART]
key. Pressing the [PAUSE] key fixes the Year
and causes the cursor to move to the Month.
8. Set the Month with the [FEED] or [RESTART]
key. Pressing the [PAUSE] key fixes the
Month and causes the cursor to move to the
Day.
9. Set the Day with the [FEED] or [RESTART]
key. Press the [PAUSE] key to fix the Day.
Then, the time currently stored in the real time
clock is displayed.
(Continued.)
ONLINE
B-SA4T V1.2
Power ON
PAUSE
RESTART
PAUSE
B-SA4T V1.2
<1>RESET
RESTART
<8>RTC SET
PAUSE
<8>RTC SET
DATE 05/01/01
PAUSE
<8>RTC SET
DATE Y 05
/01/01
Yea
To Next Page
Loading...
Need help?
General
