Name: Toshiba B-SA4T
Brand: Toshiba
Rating: 4 (1 reviews)

To Next Page

To Previous Page

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO15-33001A

2. Strip Module

2- 9

2. Open the Front Cover wider. Remove the Front Cover by lifting it to disengage the hinge pins from the

hinge. The Front Cover cannot be removed unless it is opened at an angle of over 100 degrees as the

stoppers of the hinge prevent disengagement.

3. Mount the strip Module Cover by inserting the hinge pins into the hinges.

4. Fit the Shaft Holders of the Backing Paper Feed Roller into the cuts of the printer.

Front Cove

Hinge

100°

Stopper

Hinge

Strip Module Cove

Shaft Holder

Strip Uni

Cut

Backing Paper Feed Roller

Other manuals for Toshiba B-SA4T

Questions and Answers:

Need help?

Do you have a question about the Toshiba B-SA4T and is the answer not in the manual?

General

Print Method	Thermal transfer and direct thermal
Resolution	203 dpi
Print Width	104 mm
Interfaces	Serial, Parallel, USB
Optional Interfaces	Ethernet, Wireless
Barcodes	Code 39, Code 128
2D Codes	PDF417, Data Matrix, QR Code, MaxiCode
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-20 - 60 °C (-4 - 140 °F)
Humidity	20% to 85% (non-condensing)
Interface	USB, Serial (RS-232), Parallel, Ethernet, Wireless