3.MAIN UNIT REPLACEMENT
EO18-33017
2.10 Periodic Maintenance Procedure
2-16
8. Confirm each part adjustment. Make any necessary adjustments.
9. Conduct the following tests and make sure that there is no problem.
1) Print test with TOSHIBA TEC specified media and ribbon (Print tone, print head position, etc.)
2) Paper skew
3) Print start position adjustment (Horizontal: Media position, Vertical: Sensor adjustment/Adjustment
by issuing commands)
4) Communication test
5) Abnormal noise
6) Confirm that there are not any other errors.
10. Mount the Top Cover.
11. Clean the outside of the printer.
12. Fill out a report form. Hand it to the manager and obtain a signature.
To Next Page
Loading...
