3.MAIN UNIT REPLACEMENT
EO18-33017
2.10 Periodic Maintenance Procedure
2-15
2.10 Periodic Maintenance Procedure
All machines are generally delivered in their best condition. To maintain optimal operating condition and
help gain maximum performance and life of machines, we would recommend you to conduct periodic
maintenance. Doing this is also effective in preventing unexpected troubles and avoiding wasteful system
down, by which more benefit is produced to your customers and greater reliance is placed on the product
quality.
Please refer to the following general maintenance procedure and perform periodic servicing.
NOTE: Before starting the periodic maintenance, be sure to read carefully and understand the Service Manuals,
especially warnings, cautions, and adjustment.
1. Ask an operator or a manager about any machine trouble.
2. Check the run distance on the Maintenance Counter
3. Unplug the Power Cord, and then open the Printer Cover.
4. Clean the inside of the printer.
1) The entire inside of the printer should be cleaned.
2) Wipe the Platen and the Feed Roller with a cloth moistened with alcohol.
3) Clean the Print Head Elements with a Print Head Cleaner.
(Please instruct your customers to clean them daily.)
4) Clean the Sensors.
5) Remove paper debris or label glue from the media path.
5. Apply FLOIL G-488 to the specified parts.
1) Apply grease to the Cutter Unit using a soft cloth.
6. Confirm that the problem occurs as reported, and then take corrective action.
7. Replace the following parts periodically, if necessary. The following table shows approximate product life
for each part.
No. Part Name Part No. Standard interval of replacement
1 Ribbon Motor 7FM01600000 730 km
2 Ribbon Saving Module ----------- 1,000,000 times
3 Platen 7FM01589000 50 km
FLOIL G-488
Clutch
Arm
FLOIL G-488
To Next Page
Loading...
