18
Setting Up the dynadock™ and Connecting Peripherals
2 Click Install Driver.
(Sample Image) dynadock™ U3.0 Install Menu
The following programs are installed during the installation process:
❖ DisplayLink™ Core Software
❖ TOSHIBA USB Display Drivers
3 Follow the on-screen instructions to finish the installation.
You will need to read and accept the TOSHIBA software license agreement
when prompted, to proceed with the installation.
4 Restart your computer if prompted.
Complete the software installation process before connecting the
dynadock™ to your computer.
Restarting may take longer than usual if the computer's operating system is
configured to create a system restore point after a new device is installed.
This occurs after initial installation only. When the computer restarts, the
dynadock™ is ready to use.
To Next Page
Loading...
