Installation
4
4. Read the License Agreement and tick the ‘I accept the terms in the License
Agreement’. Click the Cancel button if you do not agree and to cancel the
installation.
5. Click Next.
6. Choose the working directory for the e-BRIDGE Re-Rite installation.
Either click Next to accept the default destination (<SYSTEM DRIVE>:\Re-Rite)
or click Change to install to a different folder.
7. Assign a port number for the e-BRIDGE Re-Rite Web Control Panel so that it can
be accessed publicly.
The port number that you will use must be in the excluded list of your local
firewall. Default port number is 8080.
8. Click Next.
9. Click Install to begin the installation.
10. If e-BRIDGE Re-Rite will access network paths, you need to manually set the
Service Logon of both the e-BRIDGE Re-Rite and e-BRIDGE Re-Rite UI
services to an account that has sufficient rights to access network path.
To do this, perform the following steps:
a. Open the Service Control Manager or click Start > Run then type
services.msc.
b. Right click on e-BRIDGE Re-Rite service and click properties.
c. Click the Log On tab.
d. Click This account and set the necessary log-on account username and
password.
e. Repeat the same for the e-BRIDGE Re-Rite UI service.
When a different Web Port is selected during upgrade, the shortcut or URL
file may not be correctly updated and would still show the old Web Port, thus
preventing the user to access the e-BRIDGE Re-Rite Web Login Page.
To correct this, right-click the ‘Re-Rite’ URL file (located in the Start Menu >
e-BRIDGE folder), select Properties, then edit the URL link with the
correct port then click Apply or OK.
To Next Page
Loading...
