2.SENDING A FAX
Basic Procedures 23
2 SENDING A FAX
For details on the department management function, see the User’s Guide.
In addition, if you leave the equipment unattended for the period of the auto clear
setting time (45 sec. by manufacturer default), the screen automatically returns to the
initial one when department management is not performed, and returns to the
department code entry screen when department management is performed.
3
Set the transmission conditions as required.
Set the transmission conditions such as resolution, original mode and exposure, as
required.
P.32 “Setting the transmission conditions”
4
Specify the recipient.
P.36 “Specifying the recipient”
5
Press [START].
The originals are scanned and the fax, reserved.
If memory becomes full during scanning in the memory transmission mode, that
original will not be stored in memory. When that happens, reduce the number of
originals you are sending.
You can check the status of the current transmission. You can also cancel the
transmission (delete the job).
P.44 “Checking and Canceling the Transmissions”
A4
1
100%
01/01 12:01 M:100%
:INPUT FAX NUMBER
AUTO EXPOSURE
TEXT/PHOTO
A4
1
100%
01/01 12:01 M:100%
:0123456789_
AUTO EXPOSURE
TEXT/PHOTO
To Next Page
Loading...
