4. Scan to E-mail
40 Scanning Guide — How to Perform Scan to E-mail
How to Perform Scan to E-mail
In this function, the scanned data can be sent to the specified E-mail address as an
attached file.
NOTE: To use SCAN TO E-MAIL, the configuration of the equipment needs to be set by the
network administrator.
Scanning Procedure for Scan to E-mail
1. Place the original(s).
• For instruction about placing the originals, see Operator’s Manual for
Basic Function.
2. Press the [SCAN] button on the control panel to enter the
scan menu.
• The basic scan menu is displayed.
3. Press the [SCAN TO E-MAIL] button.
• When the SMTP Authentication is enabled by the administrator, the
AUTHENTICATION screen displayed. If the AUTHENTICATION screen is
displayed, continue to next step.
• When the SMTP Authentication is disabled by the administrator, the SCAN
TO E-MAIL screen is displayed. If the ADDRESS BOOK screen is dis-
played, skip to Step 5.
To Next Page
Loading...
