120 Setting up Scan Options
0.Setting up Scan Options
You can make various options to affect the scanning status. You can save different sets of options in files and recall
one of them for frequent use.
P.120 “Scan options”
P.122 “Scanning from the equipment on the network”
P.123 “Scanning from the equipment connected by USB cable”
P.123 “Using the Easy Set feature”
Scan options
The basic and advanced dialogs are available for the scan operation.
P.120 “Basic scan dialog”
P.121 “Advanced scan dialog”
Basic scan dialog
When you execute the image acquisition command, the following basic scan dialog appears.
1. Easy Set
The scan options can be saved.
P.123 “Using the Easy Set feature”
2.
Clears the preview image.
3. Preview screen
The pre-scanned image appears. The dotted boundary shows the scanning area or the original size. The image
information appears under the preview screen.
4.
Opens the IO Type dialog to set the destination.
P.122 “Scanning from the equipment on the network”
P.123 “Scanning from the equipment connected by USB cable”
5.
Shows the version information of the scanner driver.
6.
Shows the Help information about this scanner driver.
To Next Page
Loading...
Need help?
General
