Toshiba e-STUDIO2010AC - Page 132

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-78
 Procedures
The service technician must perform all adjustments.
(1) Select [05 ADJUSTMENT MODE]. Change the value for the code [3009] or [3011] to adjust the
reproducibility of the background when using the DF.
• The DSDF is available only for e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC.
• Set the value in increments of approximately 1, while checking the copy image until the optimum
value is obtained.
• Correlation of the background reproducibility (Setting value: [Light] 1 < 2 < 0 < 3 < 4 [Dark]):
After setting the value, copy and check the image quality.
If further image quality adjustment is necessary, go to the next step.
Color mode [05] code Recommended value
Acceptable
value range
Default
Common for full color and black
for RADF / front side for DSDF
05-3009
Set a value “3” or “4” to
increase the background
density.
Set a value “1” to decrease
the background density.
0 to 4 2
Common for full color and black
back side for DSDF
05-3011
Setting value Advantage of image quality
1
A lighter background is reproduced than the one obtained when the setting value
“2” is set.
2 Default
0
A darker background is reproduced than the one obtained when the setting value
“2” is set.
3
A darker background is reproduced than the one obtained when the setting value
“0” is set.
4
A darker background is reproduced than the one obtained when the setting value
“3” is set.