Toshiba e-STUDIO2010AC - To Closely Match the Color Balance of the Original

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-15
2.3 To Closely Match the Color Balance of the Original
 Explanation
Depending on the color balance of the original, the copy image sometimes looks different from the
original. To make the colors on the copy the same as those in the original, perform image quality control,
automatic calibration, color adjustment (color balance, RGB and hue adjustments), and color density
adjustment.
 Procedures
• You can start with any of the procedures. But it is recommended to perform the procedures in order, as
listed below. You can perform one procedure in conjunction with another. But if this changes the image
quality more than required or loses the effectiveness of the adjustment, restore the settings made in
the previously performed procedure to the original ones. Then perform other procedures.
• Both the service technician and the user can perform procedures (1) to (3).
• Only the service technician must perform procedure (4) and (5).
Before adjustment After adjustment
The copy image looks yellowish,
compared with the original.
The color balance of the copy image is
closely matched with that of the original.
Copy
Copy