2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-96
2.24.1 When adjusting the image quality of the Black mode
• Both the service technician and the user can perform step (1).
• Only the service technician can perform step (2).
(1) Press [Image] tab on the Copy mode and then press [ADF Noise Reduction].
Change the setting value of the noise reduction level.
After changing the setting value, perform printing and check its image quality.
If an additional image quality adjustment is necessary, perform the following steps.
(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7150] to [7152]
to adjust the noise reduction level.
• The smaller the value is, the larger the noise reduction level becomes. The larger the value is, the
smaller the noise reduction level becomes.
• When “0” is set for the setting value, this function becomes disabled.
After changing the setting value, perform printing and check its image quality.
Caution after the adjustment
Nothing in particular
Setting value Description
None The noise reduction function is disabled.
Low The noise reduction level is low.
Middle The noise reduction level is middle.
High The noise reduction level is high.
Color mode Original mode [05] Code Recommended value
Acceptable
value range
Default
Black
Text/Photo 7151
Set a value smaller than
100.
0 to 200 100Text 7152
User Custom 7150
To Next Page
Loading...
