Toshiba e-STUDIO2010AC - To Scan an Original with the Desired Gradation

5.Scanning-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
5-16
5.7 To Scan an Original with the Desired Gradation
 Explanation
When an original is scanned in the Black mode or the Gray scale mode, changing the scan density
according to density area (low, middle or high density area) allows a user to adjust the reproducibility of
low/middle density (gradation). Adjust the gamma curve balance, in order to change the gradation,
depending on the type of original or at a user’s request.
• This adjustment will have an effect only on the image scanned in the Black mode or the Gray scale
mode.
Before adjustment
The image is scanned with natural gradation.
(Default scanning)
After adjustment After adjustment
Gradation is decreased. Gradation is increased.