1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-3
• Image quality adjustment for 1200 dpi high-resolution printing
Press [1200 dpi Print] in step (f), in the same way as image adjustment for 600 dpi full-color
printing noted above.
After performing automatic calibration, print and check the image quality.
If further image quality adjustments are necessary, go to step (2) to adjust the transfer (2nd transfer)
roller bias output.
• Image quality adjustment with simple calibration
Use steps (a) through (d) to perform simple calibration.
(a) Press [User Functions -User-] on [Home] screen to enter the “User Functions” menu.
(b) Press [General].
(c) Press [Auto Calibration].
(d) The message “Set Auto Calibration Yes or No.” appears. Press [Yes].
After performing simple calibration, print the image and check its quality.
If further image quality adjustments are necessary, carry out the next procedure.
To Next Page
Loading...
