1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-5
• Front” refers to the printed side in the simplex mode or the side that is delivered facing upwards in
the duplex mode.
“Back” refers to the printed side that is delivered facing downwards in the duplex mode.
• The table below shows you the acceptable paper weight for the paper type.
* e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
• After adjusting the transfer roller bias output, perform automatic calibration in the same manner as
in procedure (1).
<Hint>
• The transfer voltage increases as the setting value is increased. It is usually recommended that
the setting value be increased, when you print on thick paper or paper with asperities on its
surface. On the other hand, the setting value should be decreased, when you print on thin paper.
Black
Front
Plain/Thick
paper
05-2936
0
2 to 8 0 to 10 5
Thick paper 1 1
Thick paper 2 2
Thick paper 3* 3
Transparency
(OHP film)
4
Special paper 1 5
Special paper 2 6
Recycled paper
7
Thick paper 4* 8
Thin paper* 9
Envelope 10
Special paper 3* 11
Back
Plain/Thick
paper
05-2937
0
2 to 8 0 to 10 5
Thick paper 1 1
Thick paper 2 2
Thick paper 3* 3
Special paper 1 5
Special paper 2 6
Recycled paper
7
Thick paper 4* 8
Thin paper* 9
Envelope 10
Special paper 3* 11
Paper type Acceptable paper weight
Plain paper 60 to 80 g/m² 16 to 21 lb. Bond
Thick paper 81 to 105 g/m² 22 to 28 lb. Bond
Thick paper 1 106 to 163 g/m² Max. 60 lb. Cover
Thick paper 2 164 to 209 g/m² Max. 110 lb. Index
Thick paper 3* 210 to 256 g/m² Max. 140 lb. Index
Thick paper 4* 257 to 280 g/m² Max. 100 lb. Cover
Thin paper* 52 to 59 g/m² 14 to 16 lb. Bond
Paper type [05] code
Sub
code
Recommended
value
Acceptable
value range
Default
To Next Page
Loading...
