Toshiba e-STUDIO2010AC - Page 326

5.Scanning-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
5-20
Color
mode
[05] Code
Sub
code
Adjustment
Acceptable
value
range
Default Setting value
Reference
section
Full
color
05-8371 -
Fine adjustment
of black density
0 to 4 0
The larger the value, the
darker the black side of
the image becomes.
5.6
05-8372 -
RGB conversion
method selection
0 to 3 0
Sets the color space
format of the output
image.
0: sRGB
1: AppleRGB
2: ROMMRGB
3: AdobeRGB
-
05-8373 -
Saturation
adjustment
0 to 255 128
The larger the value, the
brighter the image
becomes.
The smaller the value,
the duller the image
becomes.
-
05-8375 -
Sharpness
adjustment
The larger the value, the
sharper the image
becomes.
The smaller the value,
the softer the image
becomes and the less
moire appears.
5.5
05-8380 -
Density
adjustment
(Manual
adjustment
(Center value))
The larger the value, the
darker the image at the
center value becomes.
-
05-8381 -
Automatic
density
adjustment
When a larger value is
set, printing density
becomes darker.
-
05-8412 -
ADF noise
reduction level
setting
0 to 200 100
When the value
decreases, the effect of
reducing streaks (set
with 08-8300) becomes
larger. When the value
increases, the effect of
reducing streaks (set
with 08-8300) becomes
smaller.
5.11
05-8422 -
Contrast
adjustment
0 to 255 128
When a larger value is
set, the contrast
becomes higher. When
a smaller value is set, it
becomes lower.
-