1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-27
Pattern B for out-of-registration colors
(7) Finely adjust the rotating speed of the fuser motor, in accordance with a pattern for the out-of-
registration colors.
Use steps (a) to (b) to perform the adjustment.
(a) Select code [4529]. Finely adjust the rotating speed of the fuser motor.
• Adjust the values in accordance with a pattern for the out-of-registration colors as shown in
the table below.
(b) Select code [104], and then press [TEST PRINT]. Check all the patches on the second page of
the printed test print pattern to check whether the misaligned colors have been improved.
Pattern for
out-of-
registration
colors
[05] code Subcode Recommended value
Acceptable
value range
Default
Pattern A
05-4529 4
123 to 127
(Set a value smaller than
the current value)
0 to 255 128
Pattern B
129 to 133
(Set a value larger than the
current value)
Pa
e 1
Patch eliminated at
the leading edge
Paper feeding speed
slower than transfer
belt rotating speed
Paper feeding direction
To Next Page
Loading...
