2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-11
• When the manual setting value of the manual density is altered while it is set in the [Basic] menu
on the control panel, the density in the steps in all the indicators including the center value is also
changed. One step in the indicator corresponds to “20” of the setting value in [05] code.
After increasing the copy density, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(4) Press [Image] tab on the control panel. Press [Sharpness]. Press [Sharp] or [Soft] to adjust the
image quality.
After increasing the sharpness intensity, copy and check the copy image quality.
With the sharpness or softness intensity set to the maximum, if further image quality adjustments
are still necessary, the service technician must use the following procedure.
(5) Select [05 ADJUSTMENT MODE] and change the setting values for the codes from [7794] to [7800]
to adjust the sharpness level of the text.
• The code to use varies according to the original mode. Select the [05] code for the original mode
in which the image quality is to be changed, and start the adjustment from the setting value “128”.
• Setting “0” provides the softest image, while setting “255” provides the sharpest image.
Changing the values for these codes will change the sharpness intensity, when the [Sharpness]
indicator in the [Image] menu is set to the center. Remember that 1 step of the indicator will
Color
mode
Target Original mode [05]code
Recommended
value
Acceptable
value range
Default
Full color
Manual
density
Text/Photo 05-7713
To make the copy
density darker: Set
a value larger than
128.
To make the copy
density lighter: Set
a value smaller
than 128.
0 to 255 128
Tex t 05 - 7 71 4
Printed Image 05-7715
Photo 05-7716
Map 05-7717
User Custom 05-7718
Red Seal Color 05-7719
Automatic
density
Text/Photo 05-7720
0 to 255 128
Tex t 05 - 7 72 1
Printed Image 05-7722
Photo 05-7723
Map 05-7724
User Custom 05-7725
Red Seal Color 05-7726
Original mode [05] code Recommended value Acceptable value range Default
Text/Photo 05-7796
To make the level sharper:
Set a value larger than 128.
To make the level softer: Set
a value smaller than 128.
0 to 255 128
Text 05-7797
Printed Image 05-7798
Photo 05-7799
Map 05-7800
User Custom 05-7795
Red Seal Color 05-7794
To Next Page
Loading...
