8 WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
126 When You Think Something Is Wrong With the Equipment
Originals and paper
Problem Description Cause Corrective Action
The original is misfed. The original is unsuited for the
equipment.
Check whether the original is suitable for the
equipment.
For details, refer to Chapter 2 of the Copying
Guide.
Paper is misfed. The paper is unsuited for the
equipment.
Check whether the paper is suitable for the
equipment.
For details, refer to Chapter 1 of the Copying
Guide.
The paper size setting
registered for the equipment
is inconsistent with paper in a
drawer or on the bypass tray.
Match the size of the paper placed in the
drawer or on the bypass tray and the size
registered on the equipment.
For details, refer to Chapter 1 and 2 of the
Copying Guide.
The stack of paper exceeds
the loading line indicated on
the side guide.
Remove some paper to set it within the height
limit line indicated on the side guide. In
particular, be sure that the upper limit for thick
paper is not exceeded when placing thick
paper in the first drawer. The amount of thick
paper you can load in the drawer is lower than
that for plain paper.
There is too little or too much
clearance between the paper
and the side guide of the
drawer.
Adjust the space between the paper and the
side guide or the end guide not to take much
space.
For details, refer to Chapter 1 of the Copying
Guide.
Hidden misfed paper has not
been removed.
Check the sign again on the touch panel to
see where the misfeed occurred.
P.15 “Clearing a Paper Misfeed”
Two or more sheets of
paper are fed together.
Sheets of paper are stuck
together.
Loosen the stack of paper well and set it
again.
Sheets are not aligned
when exiting.
Sheets are not placed in the
drawer with correct side up for
this equipment.
Check the printing side of the sheets and
place them correctly. Information about the
printing side may be given on the wrapping
paper of the sheets.
If you cannot find which side is the printing
side, try printing on both sides to see if the
sheets are aligned when exiting.
The type of paper
corresponding to that being
used has not been set.
Check that the set paper type corresponds to
the paper in use.
For details, refer to Chapter 1 of the Copying
Guide.
To Next Page
Loading...
Need help?
General
