Toshiba e-STUDIO2050C - Paper Misfeed in the Bridge Kit; Paper Misfeed in the Inner Finisher and the Hole Punch Unit

1 TROUBLESHOOTING FOR THE HARDWARE
28 Clearing a Paper Misfeed
 Paper misfeed in the Bridge Kit
3
Close the Bridge Kit cover.
 Paper misfeed in the Inner Finisher and the Hole Punch Unit
1
Open the cover holding the handle of the Bridge Kit.
2
Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right
side is caught by the fuser unit, follow the steps on  P.25
“Paper misfeed in the fuser unit”.
1
Lift up the control panel and then open the front cover
of the finisher.
2
While holding the green lever, move the finisher to the
left until it stops.
2
1
2
1