1 TROUBLESHOOTING FOR THE HARDWARE
14 Messages Displayed on the Touch Panel
Error Codes
The error codes indicating the status of the equipment may appear on the touch panel. You can find the
listings of these error codes in Chapter 7.
P.110 “Error Codes”
The number of originals
exceeds the limits.
Will you copy stored
originals?
The number of originals to be
scanned has exceeded the
limit of 1000 sheets during
scanning.
To print out the data for the originals stored
(scanned) until the message appeared,
press [YES] on the touch panel. To delete
the stored data, press [NO].
LAN cable is not detected The LAN cable connection is
not detected.
Check the following items.
y Check that the LAN cable is connected
to the equipment.
y Check that there is no damage on the
connector of the LAN cable.
y Check that the LAN cable is open
circuited.
y Check that the LAN cable is connected
to the HUB. Check that there is no
damage to the connector.
y Check that the power is ON for the HUB
to which the LAN cable is connected.
y Check that the settings of the
communication speed and the Ethernet
method for the equipment and the HUB
are aligned.
Message Problem Description Corrective Action
To Next Page
Loading...
Need help?
General
