e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 100
4.7.15 SYS/HDD cooling fan (M6)
(4) Release 8 latches and remove the duct
cover [2].
Fig. 4-268
(5) Remove the process unit fan [3] by lifting up.
Fig. 4-269
(1) Remove the SYS board cover.
P. 9-1 "9.1.1 SYS Board cover"
(2) Disconnect 1 connector [1] from the SYS
board.
(3) Lift 2 latches and remove the SYS/HDD
cooling fan [2] by sliding it toward you.
Fig. 4-270
To Next Page
Loading...
