Toshiba E-STUDIO3008A - 6.13.3 Punching position center adjustment

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 72
[C] Stapling position adjustment (front 1-point)
This adjustment is performed in the Adjustment Mode (FS-05-4823-2)of the equipment.
[D] Stapling position adjustment (front 1-point / “R” series size)
This adjustment is performed in the Adjustment Mode (FS-05-4823-3) of the equipment.
[E] Stapling position adjustment (center 2-point)
This adjustment is performed in the Adjustment Mode (FS-05-4823-4) of the equipment.
[F] Stapling position adjustment (2-point pitch)
This adjustment is performed in the Adjustment Mode (FS-05-4823-5) of the equipment.
6.13.3 Punching position center adjustment
This adjustment is performed in the Adjustment Mode (FS-05-4824) of the equipment.
Adjustment scale 0.2mm
Adjustable range -5.0 mm to 5.0 mm
Adjustment direction Increasing the value The distance between the stapling position and the
edge of the paper becomes shorter.
Decreasing the value The distance between the stapling position and the
edge of the paper becomes longer.
Adjustment scale 0.2mm
Adjustable range -5.0 mm to 1.0 mm
Adjustment direction Increasing the value The distance between the stapling position and the
edge of the paper becomes shorter.
Decreasing the value The distance between the stapling position and the
edge of the paper becomes longer.
Adjustment scale 0.2mm
Adjustable range -1.0 mm to 1.0 mm
Adjustment direction Increasing the value The stapling position moves farther to the front side
from the center position.
Decreasing the value The stapling position moves farther to the rear side
from the center position.
Adjustment scale 0.2mm
Adjustable range -3.0 mm to 2.4 mm
Adjustment direction Increasing the value The pitch between the stapling positions becomes
wider.
Decreasing the value The pitch between the stapling positions becomes
narrower.
Adjustment scale 0.2mm
Adjustable range -3.0 mm to 3.0 mm
Adjustment direction Increasing the value The punching position moves farther to the front
side from the center position.
Decreasing the value The punching position moves farther to the rear
side from the center position.