e-STUDIO350/450 AUTOMATIC DUPLEXING UNIT 14 - 14 November 2003 © TOSHIBA TEC
14
[H] ADU entrance sensor, ADU exit sensor
(1) Take off the ADU, ADU inside rear cover,
ADU opening / closing switch, paper guide,
and ADU cover
( Chapter 14.5 [A] to 14.5 [E]).
(2) Disconnect the connector and release the
latch to take off the ADU entrance sensor.
(3) Disconnect the connector and release the
latch to take off the ADU exit sensor.
Fig. 14-514
Fig. 14-515
Fig. 14-516
[G] Opening /Closing lever
(1) Take off the ADU, ADU inside rear cover ,
ADU opening / closing switch, paper guide,
and ADU cover ( Chapter 14.5 [A] to 14.5
[E]).
(2) Remove 2 screws and take off the opening /
closing lever.
Fig. 14-513
ADU board
[I] ADU driving PC board (ADU board)
(1)
Take off the ADU, ADU inside rear cover , ADU
opening / closing switch, paper guide, and ADU
cover ( Chapter 14.5 [A] to 14.5 [E]).
(2) Disconnect 6 connectors and release 4 lock
supports to take off ADU board.
Screw
Opening / Closing lever
ADU entrance sensor
Connector
Connector
ADU exit sensor
To Next Page
Loading...
