November 2003 © TOSHIBA TEC 14 - 15 e-STUDIO350/450 AUTOMATIC DUPLEXING UNIT
14
[J] ADU motor
(1) Take off the ADU, ADU inside rear cover ,
ADU opening / closing switch, paper guide,
and ADU cover
( Chapter 14.5 [A] to 14.5 [E]).
(2) Disconnect 1 connector and remove the bind-
ing band.
(3) Remove 2 screws.
(4) Lift the ADU motor slightly and shift it to the
direction of the arrow to take it off.
Fig. 14-518
Fig. 14-517
Fig. 14-519
[K] ADU gear unit
(1)
Take off the ADU, ADU inside rear cover ,
ADU opening / closing switch, paper guide, and
ADU cover ( Chapter 14.5 [A] to 14.5 [E]).
(2)
Take off the ADU motor ( Chapter 14.5 [J]).
(3)
Remove 3 screws and take off the ADU gear unit.
Note:
Match the protrusion of clutch with the
position shown in the figure when assembling.
[L] ADU clutch
(1)
Take off the ADU, ADU inside rear cover , ADU
opening / closing switch, paper guide, and ADU
cover ( Chapter 14.5 [A] to 14.5 [E]).
(2) Take off the ADU motor ( Chapter 14.5 [J]).
(3) Take off the ADU gear unit
( Chapter 14.5 [K]).
(4) Remove 1 screw and disconnect the ground
wire.
(5) Disconnect 1 connector.
Fig. 14-520
ADU
motor
Screw
Ground wire
Screw
Connector
Binding band
Connector
Screw
ADU gear unit
To Next Page
Loading...
