e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-68
2. Copier-specific Adjustments
2.16.2 To Adjust the Reproducibility of Black in the Red and Black Mode
* The service technician must perform all adjustments.
(1) Enter adjustment mode [05]. Set "1" for code [1761] to change the setting, which is intended to improve the
reproducibility of black areas.
* If you are making a twin-color copy in the red and black mode, red may be blended into the black area. In
this case, switching the value for this code reduces a blend of red in the black area on the copy.
Value for 05-1761
Reproducibility of black in the red and black mode
for a twin-color copy
0 Default
1 Intended to improve the reproducibility of black
Caution after the adjustment
Setting "1" for code 05-1761 may not provide a clear boundary between red and black. Therefore, carefully
perform the adjustment, while checking the copy image.
To Next Page
Loading...
Need help?
General
