e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-78
2. Copier-specific Adjustments
2.18.2 To Adjust Custom Mode Settings in Color Mode
* All the steps in the adjustment procedure shall be performed by the service technician.
(1) Enter the setting mode [08]. Change the value for the code [506] to enable the functions of the custom mode
in the color mode.
Value for 08-
506
User mode for color mode
0 Unused
1 Used (Text/Photo base)
* The default adjustment value for the custom mode is preset at the one that reproduces image quality
equivalent to that of the Text/Photo mode in the color mode at the shipment.
After setting the value, go to the next step.
(2) Enter the adjustment mode [05]. Adjust each setting value for the custom mode to satisfy the user’s request.
• Select the necessary adjustments from the procedures below.
To make background lighter
(a) Enter the adjustment mode [05]. Increase the values for codes [7762] and [7763] to make the
background lighter.
Base
original
mode
Density
mode
[05] code Recommended value
Accepta
ble
range
value
Default
Automatic 05-7762
Text/Photo
Manual 05-7763
Set a value larger than
128.
0 to 255 128
* Set the value in increments of approximately 25, while checking the copy image until the optimum
value is obtained.
To Next Page
Loading...
Need help?
General
