e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-57
2. Copier-specific Adjustments
2.13 To Obtain a Good Color Balance on Thick Paper
Before the adjustment After the adjustment
The copy image looks light on thick paper. The copy image looks darker and sharper even
on thick paper.
Explanation
When image looks light on paper that is different from usual paper, perform automatic calibration for each paper type
to obtain the optimum image quality.
Procedures
* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed
below. You can use one procedure in conjunction with another. But if this changes the image quality more
than required or loses the effectiveness of the adjustment, restore the settings made in the previously used
procedure to the original ones. Then use other procedures.
* Only the service technician must use procedures (1), (2) and (4).
* Both the service technician and the user can use procedure (3).
To Next Page
Loading...
Need help?
General
