e-STUDIO5520C/6520C/6530C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-38
2. Copier-specific Adjustments
(1) Press the [BASIC] button on the Control Panel and select the original mode option, as follows:
• To copy in the Full color or the Auto color mode: Select the Printed image mode option.
• To copy in the Black mode: Select the Photo mode option.
* To have the above original mode options selected by default, use the following procedures:
To change the default original mode on the Control Panel
Use steps (a) to (d) to change default original mode.
(a) Press the [USER FUNCTIONS] button on the Control Panel to enter the "User Functions" menu.
(b) Press the [USER] tab.
(c) Press the [COPY] button.
(d) In the "ORIGINAL MODE FOR COLOR" or "BLACK" option, press the button corresponding to
the desired original mode option.
To change the default original mode in setting mode [08]
Enter setting mode [08]. Change the value for code [550] or [585] to change the original mode option,
which is selected by default at power-on.
• In the Black mode
Value for 08-550 Default original mode at power-on
0 Text/Photo (default)
1 Text
2 Photo
3 Image smoothing
4 Custom
• In the Full color mode
Value for 08-585 Default original mode at power-on
0 Text/Photo (default)
1 Text
2 Printed image
3 Photo
4 Map
5 Custom
* Press the [BASIC] button on the Control Panel. Select "Custom" from among the original mode options in
the Black or the Full color mode.
If the [CUSTOM] button is not displayed in the original mode option, change the values for the following
codes to enable the "Custom" mode option.
In the Black mode: Enter setting mode [08]. Set "1" for code [508].
In the Full color mode: Enter setting mode [08]. Set "1" for code [506].
After changing the default original mode option, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
To Next Page
Loading...
Need help?
General
