Toshiba e-STUDIO657 - Scanner

e-STUDIO556/656/756/856
3
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proc
edure
Service
UI
05
Adjustmen
t mode
Process
Image
quality
control
2188
Image quality open-
loop control
enforcement
- M
When a service call has occurred or a warning
message (IQC/SPC) has appeared, "Image quality
control enforcement (05-2120)" should be performed
after the equipment is repaired or the cause of the error
is evaluated. In case the service call occurred or the
warning message (IQC/SPC) appeared again after the
performance of the code 05-2120, a test chart can be
printed out by temporarily using this code (05-2188) if
an image check is urgently needed.
6
05
Adjustmen
t mode
Process Transfer
Temperature/humidity
sensor
2192 Humidity display 60 0-100 M
The humidity of the inside of the equipment is
displayed.[Unit: RH%]
2 Yes
05
Adjustmen
t mode
Process Transfer
Temperature/humidity
sensor
2194 Temperature display 22 0-50 M
The temperature of the inside of the equipment is
displayed.[Unit: °C]
2 Yes
05
Adjustmen
t mode
Process
Image
quality
control
2196
Latest value of drum
temperature
22 0-100 M
A drum surface temperature detected at the drum
surface potential sensor control is displayed.
2
05
Adjustmen
t mode
Process
Image
quality
control
2198
Relative humidity
display at image
quality closed-loop
control
55 0-99 M
A relative humidity detected at the image quality
closed-loop control is displayed.
2
05
Adjustmen
t mode
Process
Image
quality
control
Laser power
adjustment
2250 0 1st laser
Refer to
contents
0-255 M
When the value increases, the laser power output
increases.
<Default value>
e-STUDIO556/656: 132
e-STUDIO756/856: 101
14 Yes
05
Adjustmen
t mode
Process
Image
quality
control
Laser power
adjustment
2250 1 2nd laser 101 0-255 M
When the value increases, the laser power output
increases.
Valid only for e-STUDIO756/856
14 Yes
05
Adjustmen
t mode
Scanner Scanner 3009
Log table switching
for RADF copying
(color)
0 0-4 SYS
0: Same log table as the one used at copying with
original glass
1: Background reproduction - Light 2
2: Background reproduction - Light 1
3: Background reproduction - Dark 1
4: Background reproduction - Dark 2
1
05
Adjustmen
t mode
Scanner Scanner
Image location
adjustment
3030
Primary scanning
direction (scan.
section)
113 0-255 SYS
When the value increases by "1", the image shifts by
approx. 0.0423 mm toward the front side of the paper.
1 Yes