Toshiba e-STUDIO657 - Printer

e-STUDIO556/656/756/856
5
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proc
edure
Service
UI
05
Adjustmen
t mode
Scanner Scanner 3047
Carriage position
adjustment during
scanning from RADF
(color)
128 0-255 SYS
When the value increases by "1", the carriage position
shifts by approx. 0.1 mm toward the exit side when
using the RADF.
1
05
Adjustmen
t mode
Scanner Scanner
Data transfer of
characteristic value
3203
SLG board -> SYS
board
- - SYS
Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction)
6 Yes
05
Adjustmen
t mode
Scanner Scanner 3209
Data transfer of
characteristic value of
scanner / SYS board
→ SLG board
- - SYS
Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction) from the SRAM of
the SYS board to the SRAM of the SLG board.
6
05
Adjustmen
t mode
Scanner RADF 3210
Original reading start
sensor Auto adj.
- - -
Perform the adjustment and initialization when the
RADF board or RADF original reading start sensor is
replaced.
6 Yes
05
Adjustmen
t mode
Scanner Scanner
Shading correction
plate
Automatic dust
detection adjustment
3218
Shading correction
plate
Automatic dust
detection adjustment
- - -
Performs adjustment for automatic dust detection with
the shading correction plate. If dust is detected,
shading correction is performed by avoiding the dust.
6
05
Adjustmen
t mode
Scanner RADF EEPROM initialization 3220 EEPROM initialization - - - Initializes EEPROM for the RADF. 6
05
Adjustmen
t mode
Scanner RADF 3221
Original reading start
sensor Manual adj.
- - -
Adjusts the RADF original reading start sensor of the
RADF manually.
6 Yes
05
Adjustmen
t mode
Printer Printer
Fine adjustment of
polygonal motor
rotation speed
Adjustment of primary
scanning direction
reproduction ratio
4000 PPC 128 0-255 M
When the value increases in increments of "1", the
reproduction ratio of the primary scanning direction
increases as follows:
e-STUDIO556/656: 0.3 mm/step
e-STUDIO756/856: 0.1 mm/step
1 Yes
05
Adjustmen
t mode
Printer Printer
Fine adjustment of
polygonal motor
rotation speed
Adjustment of primary
scanning direction
reproduction ratio
4001 PRT 128 0-255 M
When the value increases in increments of "1", the
reproduction ratio of the primary scanning direction
increases as follows:
e-STUDIO556/656: 0.3 mm/step
e-STUDIO756/856: 0.1 mm/step
1 Yes