Toshiba e-STUDIO657 - Page 353

e-STUDIO556/656/756/856
10
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce
dure
Servic
e UI
08
Setting
Mode
Process Transfer
Transfer correction
value
Thick paper2 2930 1 C 106 0~255 M
The output value of the transfer bias at the center of the
paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Thick paper2 2930 2 L 150 0~255 M
The output value of the transfer bias at the trailing edge
of paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Duplex printing 2931 0 H 128 0~255 M
The output value of the transfer bias at the leading
edge of paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Duplex printing 2931 1 C 128 0~255 M
The output value of the transfer bias at the center of the
paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Duplex printing 2931 2 L 128 0~255 M
The output value of the transfer bias at the trailing edge
of paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Transparency 2932 0 H 150 0~255 M
The output value of the transfer bias at the leading
edge of paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Transparency 2932 1 C 106 0~255 M
The output value of the transfer bias at the center of the
paper is corrected.
4
08
Setting
Mode
Process Transfer
Transfer correction
value
Transparency 2932 2 L 150 0~255 M
The output value of the transfer bias at the trailing edge
of paper is corrected.
4
08
Setting
Mode
Process Transfer 2960
Transfer timing
correction
2 0~4 M
The timing to turn on the transfer bias is corrected.
<e-STUDIO556/656>
0: Approx. 8.2 mm passed from the reference position
1: Approx. 6.8 mm passed from the reference position
2: Approx. 5.4 mm passed from the reference position
3: Approx. 4.1 mm passed from the reference position
4: Turns on at the reference position
<e-STUDIO756/856>
0: Approx. 9.8 mm passed from the reference position
1: Approx. 8.2 mm passed from the reference position
2: Approx. 6.6 mm passed from the reference position
3: Approx. 4.9 mm passed from the reference position
4: Turns on at the reference position
1
08
Setting
Mode
Process Transfer
Transfer timing
correction
Thick paper3 2961 0 H 150 0~255 M 4
08
Setting
Mode
Process Transfer
Transfer timing
correction
Thick paper3 2961 1 C 106 0~255 M 4