Toshiba e-STUDIO657 - Page 505

e-STUDIO557/657/757/857
5
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce
dure
Servic
e UI
05
Adjustmen
t mode
Scanner Scanner
Data transfer of
characteristic value
3203
SLG board -> SYS
board
- - SYS
Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction)
6
05
Adjustmen
t mode
Scanner Scanner 3209
Data transfer of
characteristic value of
scanner / SYS board
→ SLG board
- - SYS
Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction) from the SRAM of
the SYS board to the SRAM of the SLG board.
6
05
Adjustmen
t mode
Scanner RADF 3210
Original reading start
sensor Auto adj.
- - -
Perform the adjustment and initialization when the
RADF board or RADF original reading start sensor is
replaced.
6 Yes
05
Adjustmen
t mode
Scanner Scanner
Shading correction
plate
Automatic dust
detection adjustment
3218
Shading correction
plate
Automatic dust
detection adjustment
- - -
Performs adjustment for automatic dust detection with
the shading correction plate. If dust is detected,
shading correction is performed by avoiding the dust.
6
05
Adjustmen
t mode
Scanner RADF EEPROM initialization 3220 EEPROM initialization - - - Initializes EEPROM for the RADF. 6
05
Adjustmen
t mode
Scanner RADF 3221
Original reading start
sensor Manual adj.
- - -
Adjusts the RADF original reading start sensor of the
RADF manually.
6 Yes
05
Adjustmen
t mode
Scanner Scanner
Size detection of
original
3233
Position adjustment in
the primary scanning
direction
Refer to
contents
0-255 SYS
Adjusts the detection range for size of original.
<Default value>
NAD/TWD/CND: 128
Others: 58
1
05
Adjustmen
t mode
Scanner Scanner
Size detection of
original
3234
Waiting position
adjustment of
carriage
200 0-255 SYS
Adjusts the position where the carriage stops at the
size detection of the original.
Default value: 200 (20 mm from leading edge of
original)
Maximum value: 255 (25.5 mm from leading edge of
original)
Minimum value: 0 (0 mm from leading edge of original)
1
05
Adjustmen
t mode
Scanner Scanner
Size detection of
original
3236
Adjustment of lamp
lighting time
128 0-255 SYS
Adjusts the lighting time of the lamp at the size
detection of the original.
Maximum value: 255 (Minimum time + 2040ms)
Minimum value: 0 (Minimum time)
1