Toshiba e-STUDIO657 - Page 630

e-STUDIO557/657/757/857
61
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce
dure
Servic
e UI
08
Setting
Mode
Printer Counter Tray-up abnormality 4th drawer 4671 1 2 times in a row 0 0~255 M
Displays the number of the tray-up abnormality
occurrences which are generated 2 times in a row.
An error is counted when "1" is set for 08-4665, and is
listed in the error history.
4
08
Setting
Mode
Printer Counter Tray-up abnormality 4th drawer 4671 2
At least 3 times in a
row
0 0~255 M
Displays the number of the tray-up abnormality
occurrences which are generated at least 3 times in a
row. The 3 times error is counted as 1, the 4 times one
is 2, the 5 times one is 3 and the later ones are counted
consequently.
An error is counted when "1" is set for 08-4665.
4
08
Setting
Mode
Printer Counter Tray-up abnormality 4th drawer 4671 3
Total number of
occurrences
0 0~255 M
Displays the total number of tray-up abnormality
occurrences.
An error is counted when "0" is set for 08-4665, and is
listed in the error history.
4
08
Setting
Mode
Printer General 4675
Paper ejection setting
for wrong bypass
paper size
2 0-2 M
0: Disabled
1: Changes jammed paper location
2: Ejects paper
1
08
Setting
Mode
Printer Counter 4676
Ejection counter for
wrong bypass paper
size
0 0-65535 M Number of ejection times 1
08
Setting
Mode
Printer General 4686
Printer ROM version
display at printer all
clear
- - M
Displays the low 2 or 3 digits of the printer ROM version
(08-9901) when printer all clear (08-9090) is performed.
The version number is described by alphanumeric
characters.
2
08
Setting
mode
Printer General 4718
Prior start-up of
warming up
1 0-1 M 0: Disabled 1: Enabled 1
08
Setting
mode
Printer Laser
Number of beam
detection error
4740 0 A beam 0 0-255 M
This code is used to investigate the cause of image
trouble. Only "0" can be input. (Unit: number of times)
4
08
Setting
mode
Printer Laser
Number of beam
detection error
4740 1 B beam 0 0-255 M
This code is used to investigate the cause of image
trouble. Only "0" can be input. (Unit: number of times)
4