e-STUDIO557/657/757/857
119
element
code
value
value
dure
e UI
Mode
interface
information
with password
9
Password for zip file with password of service
notification information.
Minimum number of digits: 0, maximum number of
digits: 20
Available character: alphanumeric characters and
symbols
Mode
interface
when Super Sleep is
enabled
Sets the operation when the power button on the
control panel is press for a few seconds if Super Sleep
is enabled.
0: Hibernation
1: Super Sleep
Mode
interface
the screen of control
panel at start-up
Use this code to shorten the time to switch the function
on the control panel for the first time immediately after
start-up. However, the start-up time becomes longer
(about 1 to 3 seconds per screen). When selecting
multiple screens, enter the total value.
0: Disabled
1: Copy
16: Fax
Mode
network
communication
Normally there's no need to change the MTU value. Set
the proper MTU value when MFP is connected to the
Internet using broadband router and so on.
Mode
interface
display with asterisk
0: Displays department code with asterisk when
inputting it.
1: Displays department code as it is when inputting it.
Mode
sending at AutoClear
when scanning
original put on the
glass
Sets whether the job is sent or canceled when
AutoClear is executed on the interruption screen to
confirm the next original displayed after scanning the
original put on the glass. Use this code to cancel job
when the equipment is left unattended while the
interruption screen is displayed.
0: Sends job
1: Cancels job