128 P9 ASD Installation and Operation Manual
EOI (Panel) Operation Jog Mode
Program Frequency Jog Settings
This parameter enables the Jog command to be received from the EOI. When
disabled, the Jog command received from the EOI is ignored.
Jog commands may also be received from the Terminal Board. Priority as to
which is allowed to override the other is selected at
F106.
The priority selection at F106 enables the selected source for Jog control and
disables the other. The F106 setting overrides the F262 setting.
Settings:
0 — Disabled
1 — Enabled
Direct Access Number — F262
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
F262 F262
To Next Page
Loading...
