Toshiba P9 - Page 85

P9 ASD Installation and Operation Manual 75
Figure 33. Complete the Virtual Linear Pump Setup.
Figure 34. Run the Motor/Pump in the Direct Mode.
14. Press the Stop key to complete
the setup.
15. Click Exit to save settings
(Exit becomes available at zero
Hz).
16. From the Frequency
Command screen, press ESC
and scroll to the Virtual Linear
Pump Control field. Select
Direct Mode if using no
feedback (if using feedback, go
to Step 19. on pg. 76).
17. While in the Hand mode, and
from the Frequency Command
screen, press Run.
18. During operation, adjust param-
eters F500 and F501 to stabilize
operation if unstable.
Press ESC