4.7 Keyboard 4 Replacement Procedures
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-6 to Figure 4-9.
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3230 on the system board.
3. Install the keyboard support plate and secure it with the following screw.
• M2×12BS S-THIN HEAD screw ×1
4. Turn the keyboard face up and set it in place.
5. Secure the keyboard with the following screws.
• M2×2.5B S-THIN HEAD screw ×2
CAUTION: Make sure the FPC does not touch the cover-rib.
6. Install the keyboard holder (L/R) and touch pad mask and press to secure the
latches.
NOTE: Stick the insulator to the keyboard cable if the new keyboard is installed.
Insulator
Figure 4-9 Installing the keyboard
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-17
To Next Page
Loading...
