Toshiba PORTEGE R300 - Wireless LAN Card

4 Replacement Procedures 4.20 Wireless LAN card
4.20 Wireless LAN card
Removing the Wireless LAN card
To remove the wireless LAN card, follow the steps below and refer to Figure 4-31.
1. Remove the following screws securing wireless LAN card.
• M2×4B S-THIN HEAD screw ×2 (for model without wireless LAN card cover)
• M2×4B Security torx screw ×1 (for models with wireless LAN card cover)
2. Disconnect the wireless LAN card from the connector CN2600 on the system board.
M2×4B S-THIN HEAD
Wireless LAN card
M2×4B Security torx
Wireless LAN card cover
(Some models are not
equipped with the wireless LAN
card cover)
CN2600
Figure 4-31 Removing the wireless LAN card
Installing the Wireless LAN card
To install the wireless LAN card, follow the steps below and refer to Figure 4-31.
1. Insert slantingly the wireless LAN card into the connector CN2600 on the system
board.
2. Gently push the wireless LAN card down and secure the wireless LAN card with the
following screw.
• M2×4B S-THIN HEAD screw ×2 (for model without wireless LAN card cover)
• M2×4B Security torx screw ×1 (for models with wireless LAN card cover)
4-40 [CONFIDENTIAL] PORTÉGÉ R300 Maintenance Manual (960-591)
All manuals and user guides at all-guides.com