Toshiba PORTEGE R300 - Cover FAT Assembly

4 Replacement Procedures 4.8 Cover FAT assembly
4.8 Cover FAT assembly
Removing the Cover FAT assembly
To remove the Cover FAT assembly, follow the steps below and refer to Figure 4-10 to
Figure 4-12.
1. Remove the following screw of the bottom cover.
• M2×6BS S-THIN HEAD screw ×6
4
2 1
5
3
6
Figure 4-10 Removing the Cover FAT assembly (1)
2. Remove the following screw of the backside.
• FB2.5×5C ×2
FB2.5×5C
Figure 4-11 Removing the Cover FAT assembly (2)
3. Peel off the insulator that prevents a waterdrop from entering the computer and
disconnect the fingerprint sensor cable from the connector CN9520 on the system
board.
4-18 [CONFIDENTIAL] PORTÉGÉ R300 Maintenance Manual (960-591)
All manuals and user guides at all-guides.com