4.15 HDD 4 Replacement Procedures
CAUTION: Do not apply pressure to the top or bottom of the HDD.
HDD bracket
M3×4S FLAT HEAD
M3×4S FLAT HEAD
HDD
Figure 4-24 Removing the HDD (only 2.5” HDD model)
Installing the HDD (only 2.5” HDD model)
To install the HDD, follow the steps below and refer to Figure 4-22 and Figure 4-24.
CAUTION: Do not hold the HDD by its top and bottom flat surfaces. It may damage the
HDD.
1. Seat the HDD in the HDD bracket and secure them with the following screws.
• M3×4S FLAT HEAD screw ×4
CAUTION: Do not apply pressure to the center of the HDD assembly. It may damage
the HDD assembly. Hold the HDD assembly by its corners.
2. Connect the HDD cable to the HDD assembly.
3. Connect the HDD cable to the connector CN1850 on the system board.
4. Install the HDD assembly to the base assembly.
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-33
To Next Page
Loading...
